This helps loosen any extra eraser filings that could be trapped under the heat spreaders. Tip: I have also found an additional benefit to lightly tap the RAM modules against a clean flat surface along the bottom edge where the copper contacts are. Give the RAM a blow with compressed air to make sure there are no bits of debris or dust left on the contacts or under the heat spreaders. You must ensure that all the eraser filings or any eraser deposits have been cleaned off properly. This is a step that is very important to get right. Clean off the eraser filingsĪfter giving the contacts a good clean with the eraser, take a cloth and keep wiping them until it feels smooth or once you are convinced that there are no traces of eraser filings left. Turn the RAM module over and repeat the process on the other side. You will notice the first few strokes will most likely result in the eraser end becoming a bit dirty. Use the pencil eraser in short strokes, all of the contacts back and forth until the eraser end is clean. Lay the RAM module down on a flat, clean surface. It simply means you must be extra cautious when removing or installing RAM. If one is fixed and cannot move, it’s perfectly normal, as some motherboards are designed this way. Remove the case lid and remove the RAM from the slots by gently releasing the clips on either end of the slots. Unplug your computer from power and everything else to move it to an uncluttered work area.īefore touching any internal components, touch the case first to help reduce any built-up electrostatic charge you may have accumulated. Prepare a good enough workspace to remove the RAM It will make the job of cleaning them far easier. Remove the case if your computer is dusty inside before pulling out any RAM modules. It’s always best to keep those things away from such delicate surfaces. I do not recommend using any solvents or sprays when cleaning RAM. It has taught me that RAM doesn’t go faulty nearly as often as most would think. I have found that this method has reduced the amount of RAM replacement by way more than half. To outline the process, all we are going to do is clean the module’s contacts and the slots. Steps on how to clean RAM module contacts Keeping your computer clean is one thing, but your RAM is so important to keep your computer stable and reliable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |